Capture13

PT4RO - 4 Relay Output Module

The PT4RO module has 4 normally open/ normally closed relay outputs. These modules may be used when a higher drive capability is required, or when isolation between outputs are required.

Each output can be individually switched on or off, or all outputs can be set up at the same time by writing a single number to the output register which represents the status of all outputs.

An output watchdog timer can be configured to switch off all the outputs if there has been no communications with the module for up to 255 seconds. A value of 0 seconds will disable this timer and the outputs will remain in the last programmed state.

pt4ro

Order Codes

  • PT4RO - PROMUX TCP 4 Relay Output Module

SCADA software for people with other jobs!

Click here to see  the Procon User Manual.